Cleverly doing printing rules to improve work efficiency

Calibrating staff in the actual work of the amount of rules is too much trouble, need to use one foot on one side of the amount, very inconvenient, and the accuracy is not high, resulting in long-term exposure to ultraviolet radiation on the health of the operator. In order to protect the health of operators and improve product quality and work efficiency, we have tried to do lithography rules, the specific approach is as follows.

Take the example of a printing plate of 92cm*76cm and a copy of 7cm:

1. Get a 50cm new plexiglass ruler.

2. Use SO film to copy two 46cm-long female rulers.

3. Copy 7cm long negative film ruler three.

4. Wash and dry.

5. Using a copy of the two 46cm cavity rulers, a ruler with a median length of 46cm (i.e., 1 to 46 cm from the left and 1 to 46 cm from the right) was used.

6. Then fight 7cm straight on the left side of the straight spell, 7cm straight on the centerline, and 7cm straight on the right.

7. Then in the film below the left and right rulers fight a signal strip as a mark for the quality of inspection printing, such a negative chart printing rules can be completed.

8. With the spelling of the negatives, copying the rules and printing the sun-curing rules can be used for positive printing.

Through our practical work, we prove that the improved printing plate has the following advantages:

1. Double ergonomics.

2. The operator's exposure to UV light is reduced by half, which is beneficial to the operator's health.

3. It is simple to make and easy to operate.

4. Improve the quality of printing.

5. The use of signal strips can further detect the quality of each process and is conducive to plate-making data manipulation.