The charter is also called the strapping machine. Here are some faults and troubleshooting methods that are easy to appear in the charter.
Situation 1:
Cassette processing, when the tape is stuck in the middle of the roller, or when there is a foreign body clogged and cannot be removed, the processing method is as follows:
a. Disassemble the washer of the hexagon nut.
b. Loosen the two M5 countersunk screws on the center connecting shaft. Since these two screws are fixed in the notch of the connecting shaft, the screws must be turned on.
c. Remove the connecting shaft, pick up the upper turbine, and remove the jammed objects.
d. Assemble and restore according to the above cba method.
e. Note that the gap between the nut and the L-shaped curved plate is 0.3-0.5mm
Situation 2:
The automatic packing machine does not automatically take out the tape. In this case, first check whether the "out of tape length adjustment" is at "0", and then see if the tape passing process is correct. If it does not work, foreign objects are stuck near the tape feed roller, which will also cause One situation.
Situation 3:
Do not cut the tape after tying it up, there are many situations that can cause this.
a, the tightness adjustment is too tight
b. The slipper or slipper belt has oil, which is located near the tightness adjustment, and must be removed to wipe off the oil.
c. The belt is too tight. Adjust the belt drive seat down or adjust the motor backward.
d. Switch to a thinner belt or withdrawing roller clearance is too large. The charter is also called the strapping machine. Here are some faults and troubleshooting methods that are easy to appear in the charter. [next]
Condition four:
The bonding effect is not good.
a. The temperature is too high or not enough. Sometimes the special tape has poor viscosity and the temperature must be very accurate.
b. The use voltage is not enough, there are many factories, the voltage is often insufficient, if you use extension cord or cable, it will cause a voltage drop, make the originally adjusted temperature lower, or even burn out when the motor is tied, so try to avoid using cables If you must use an extension cord, connect a thicker cord rather than a long one.
c. The 635 bearing under the middle knife is broken, so it is heated and cannot be bonded at all.
d. The long tension spring on the electric heating hand (swing rod) is tired, so the hand can not be pulled to the position, resulting in half or less bonding.
e. The heating steel sheet is too high or too low, or it is on the left or right, so it hits the upper and lower PP belts, or the left and right tools, and cannot enter the heating. It must be adjusted according to the situation.
f. The exhaust fan's micro-fan is faulty, which makes the temperature too high.
Condition five:
No action when inserting the tape.
The LS1 micro switch on the right side of the upper skateboard is faulty or the shrapnel is blocked by a foreign object and cannot touch the contact.
Condition 6:
continuously working.
a, LS5 failure
b. Although the LS1 is not faulty, there is stolen goods between the contacts and the shrapnel, or the shrapnel itself is stuck, so that the contacts cannot be released after the tape is inserted as usual.
c. When the LS5 returns to zero, the contact is not closed, so the power supply will work continuously as soon as it is turned on.
Condition 7:
Cut off without tightening.
a. The tightness of the machine is too loose, just tighten it.
b. The position of LS3 and LS5 is improper.
c. The magnetic induction switch withdrawing is faulty.
ZHONGSHAN GRUWILL HARDWARE CO.,LTD , https://www.zsgruwill.com