The plate processor must be installed on a flat, clean indoor floor. For the convenience of operation and maintenance, the space left and right of the machine must be no less than 750mm wide. The machine must have sufficient entry and exit space before and after the machine. This article will introduce you to the Kodak ctp processor.
The plate machine uses a low concentration of glue in the gluing process, and oxidation of the non-image part will cause the plate of the plate to become dirty. The solution to this kind of problem is: the plate surface of the plate machine should be fully washed after being dirty. When the plate machine is glued, the glue concentration should be increased, and the glue should be evenly distributed; after the dirty note is used up, it should be tightly closed; Version, the plate length of the plate machine is dried and then printed.
The thermal plate-making machine is equipped with an emergency stop switch on the imported plate feeding table; it is convenient for handling problems under special circumstances and avoiding unnecessary troubles. The washing machine drys the overheating automatic protection device; the liquid level is too low, the automatic replenishing device; the mechanical transmission system's closed protection device; and the safety warning sign of the safety important parts of the plate machine are safely designed.
Whether the parts of the platen machine are damaged due to transportation, if any, immediately make a corresponding record and take pictures of the damaged part, and contact the carrier or supplier in time. A 4 minute tap water pipe should be connected to the equipment room. The height of the machine room drain should not be 150mm higher than the floor space of the platen machine. In order to facilitate the cleaning of the roller shaft and other parts, a properly sized pool should be provided in the equipment room.
Article source address: http://
Ningbo XISXI E-commerce Co., Ltd , https://www.petspetscleaning.com